低压成套开关设备 GGD

10-.jpg

产品简介
Brief introduction to the products

GGD型交流 低压配电柜适用于发电厂、变电站、厂矿企 业等电力用户的交流50Hz,额定工作电压380V,额定工作电流至3150A的配电系统,做为动力、照明及 配电设备的电能转换、分配与控制之用。

The GGD AC Low-Voltage Distribution Cabinet is suitable for power plants, substations, factories and mines, AC 50Hz, rated working voltage 380V, rated woeking current up to 3150A, as power, lighting and the power conversion and control of the power distribution equipment.

结构特点及功能
Structural Characteristics and Functions

★柜体采 用通用柜的形式,构架用8MF冷弯型 钢局部焊接组装而成,构架零 件及专用配套零件由型钢定点生产厂配套供货,以保证 柜体的精度和质量;

★在柜体 上下两端均有不同数量的散热槽孔,当柜内 电器元件发热后,热量上升,通过上端槽孔排出,而冷风 不断地由下端槽孔补充进柜,使密封 的柜体自下而且上形成一个自然通风道,达到散热的目的;

★柜门用 转轴式活动铰链与构架相连,安装、拆卸方便。门的折 边处均嵌有一根山型橡塑条,开门时 门与构架之间的嵌条有一定的压缩行程,能防止 门与柜体直接碰撞,也提高 了门的防护等级。

★柜体的 顶盖在需要时可拆除, 便于现 场所主母线的装配和调整,柜顶的四角装有吊环,用于起吊和装运。


The cabinet is of common form. The framework is composed of 8MF cold bending profile steel welded and assembled. The frame parts and the special necessary parts are provided by the specially appointed manufacturers so as to ensure the precision and quality of the cabinet;

At the upper and lower ends of the cabinet there are different numbers of cooling slots. When the electrical components inside of the cabinet are scattering heat,  the heat in the cabinet is increased and discharged through the top cooling slots while the cooling air is entering constantly the cabinet through the bottom cooling slots, forming from bottom to top a natural ventilation duct to scatter the heat;

The door of the cabinet is connected with the axis hinge to the framework and the disassembling is rather convenient. A rubber insertion strip is fixed at the edge of the door for avoiding direct collision of the door with the cabinet, increasing the protection level of the door.

The cap of the cabinet can be removed, if necessary, for the convenience of assembling and adjustments of the main buses. The lifting rings are fixed at four corners of the top of the cabinet for lifting snd transportation.


技术参数
Product Structure

未标题-20.jpg


外形及安装尺寸
Type and Dimensions

未标题-21.jpg

未标题-22.jpg

使用条件
Conditions of Use

※ 周围空气温度不高于+40℃,不低于-5℃。24小时内 的平均温度不高于+35℃。

※ 户内安装使用,使用地 点的海拔高度不得超过2000M。

※ 周围空 气相对湿度在最高温度为+40℃时不超过50%,在较低 温度时允许有较大的相对湿度。(例如+20℃时为90%)应考虑 到由于温度的变化可能会偶然产生凝露的影响;

※ 设备安 装时与垂直面的倾斜面度不超过5度;

※ 设备应 安装在无剧烈震动和冲击的地方,以及不 足使电器元件受到腐败蚀的场所。


Ambient Temperature ≥-5℃ ≤+40℃; Average temperature within 24 hours ≤ +35℃.

Indoors. Height above Sea Level ≤ 2000 M.

Relative Humidity: ≤ 50% at +40℃ (Max); At a lower temperature to allow a greater relative humidity (for example 90% at +20 ℃). It should be considered that due to the temperature variation, the jel phenomenon may be effected.

For installation, the tilt of the vertical surface does not exceed 5°

The installation site should be free from violent vibration, impact and corrosion of the electrical components.


    友情链接:    彩世界彩票官网   莱利彩票登陆   本站彩票_安全购彩   莱利娱乐彩票   彩12彩票注册